Outfeed Table - Grizzly G0605X Owner's Manual

11. Fasten each support leg to the main exten-
sion table with four phillips head screws and
flat washers as shown in figure 17.
figure 17. support leg fastened to main
extension table.
12. rotate both feet until they touch the ground,
and tighten the hex nuts to secure the feet.
13. Fasten the shelf end plate to the legs with
four phillips head screws and flat washers as
shown in figure 18.
figure 18. installing shelf end plate on extension
table legs.
14. place the shelf brackets between the cabinet
and support legs, and fasten with four m6-1
x 12 hex bolts, four flat washers and two hex
nuts (on the outside) as shown in figure 19.
Note: The flange on the shelf bracket must point
up to ensure proper installation.
15. place the lower shelf on the brackets.
model g0605X/g0606X (mfg. since 11/06)
shelf Bracket
figure 19. shelf brackets installed.

Outfeed Table

components and hardware Needed:
outfeed table .................................................... 1
lower shelf ........................................................ 1
shelf End plate .................................................. 1
support legs ..................................................... 2
lower shelf Brackets ......................................... 2
Fence tube ........................................................ 1
Flange Bolts m8-1.25 x 16 ................................ 2
hex Bolts m6-1 x 12 .......................................... 4
phillips head screws m6-1 x 12 ..................... 12
Feet 3 ⁄ -16 x 2 .................................................... 2
8
hex nuts m6-1 .................................................. 2
hex nuts m8-1.25 ............................................. 2
hex nuts ⁄ -16 .................................................. 2
3
8
Flat Washers 6mm .......................................... 16
Flange Bolts m8-1.25 x 12 ................................ 9
To install the outfeed table:
1.
turn the outfeed table upside down and
place it on a level surface.
2.
install the feet, support legs, and shelf end
plate in the same manner as described in
Extension Table instructions.
Flange
Qty
-21-