Installing the Software and Initially Configuring a
CDE
This chapter describes the initial installation of the Cisco Internet Streamer CDS release 2.0 software
application suite, and the initial configuration of the CDE.
This chapter contains the following sections:
•
•
•
•
•
Before You Begin
You need the following to perform the initial installation and configuration of the CDS:
•
•
•
•
•
•
On the CDE-200, se the USB port to connect the USB CD-ROM drive. After the initial installation,
Note
remove the USB CD-ROM drive. The internal compact flash IDE drive becomes the boot drive for
subsequent operations.
OL-13478-01
Before You Begin, page 3-1
Running the BIOS Setup Utility, page 3-3
Installing the Software, page 3-13
Initially Configuring a CDE, page 3-14
Verifying the CDSM, page 3-15
CDE
USB CD-ROM drive (for CDE-200 only [provided])
Internal IDE compact flash drive (pre-installed)
Terminal server connection with the following parameters:
–
9600 baud
8 bits
–
No parity
–
Redirection After BIOS POST is off in CDE BIOS setup
–
Console redirection enabled for COM1
–
CDS image CD
Network connection
C H A P T E R
Cisco Content Delivery Engine Hardware Installation Guide
3
3-1