Advertisement
Crushing hazard! Always
keep hands clear when
using this machine.
5.
With workpiece secured by clamping leaf,
lift bending levers to bend workpiece (see
Figure 13).
Tip: Use protractor to measure bend angle.
Figure 13. Example of workpiece ready for
bending operation.
6.
Open clamps and clamping leaf and remove
workpiece.
-6-
Workpiece
Bending Lever
(1 of 2)
Adjusting Clamps
If changing to a different workpiece thickness, the
clamps will likely need to be adjusted to securely
clamp the workpiece.
Items Needed
Hex Wrench 8mm .............................................. 1
Open-End Wrench 24mm .................................. 1
To adjust clamps:
1.
Use 8mm hex wrench to keep clamp adjust
stud from turning and adjust hex nuts shown
in Figure 14.
Figure 14. Clamp adjusting components.
— Turn nuts clockwise for thinner workpiece.
— Turn nuts counterclockwise for thicker
workpiece.
2.
Repeat adjustment from Step 1 on second
clamp, taking care to adjust both the same
amount.
Model T32714 (Mfd. Since 05/21)
Qty
Clamp Adjust Stud
Adjusting
Hex Nuts
Advertisement
