Honeywell T775A Series Installation Instructions Manual page 16

T775A/B/M SERIES 2000 ELECTRONIC STAND-ALONE CONTROLLERS
PROGRAM
RELAY 1
SENSOR
Fig. 32. Program - Sensor.
PROGRAM
RELAY 1
HEAT/COOL
Fig. 33. Program - Heat/Cool.
PROGRAM
RELAY 1
SETBACK
Fig. 34. Program - Setback.
62-0254—13
All manuals and user guides at all-guides.com
1.2.3. SENSOR
MENU
PROGRAM
RELAY 1
SENSOR
1. From the menu, use the
SENSOR A
SENSOR B
2. Press the
3. Use the
4. Press the
SELECT
SENSOR FOR
RELAY 1
M24496
1.2.4. HEAT/COOL
MENU
PROGRAM
RELAY 1
HEAT/COOL
1. From the menu, use the
HEAT
COOL
2. Press the
3. Use the
4. Press the
SELECT
HEAT/COOL
FOR
RELAY 1
M24497
1.2.5. SETBACK
MENU
PROGRAM
RELAY 1
The Setback temperature option displays if scheduling is
SETBACK
enabled (See Fig. 57 on page 24) or the DI Option is set
to Setback. (See Fig. 60 on page 26).
This is the desired setpoint temperature that you want to
use during setback mode for this output. For example, if
60
o
F
your setpoint is 70° F (21° C) and you want the
temperature to drop 10° F during setback mode, enter
60° F (16° C) as the setpoint for this output.
ENTER
SETBACK
SETPOINT
1. From the menu, use the
FOR RELAY 1
M24498
2. Use the
3. Press the
1.2.6. Program Next Output
For the next output (Mod or Relay), select the desired
output from the Program menu (Refer to Fig. 28 on
page 14).
Go to "1.2.1. SETPOINT" on page 15 to program the next
output.
When you finish programming the outputs, continue with
"1.2.7. Exiting Program Mode" on page 17.
16
highlight SENSOR.
button to display the sensor selec-
tions.
and buttons to select Sensor A or
B.
button to accept the highlighted sen-
sor and display the next option.
highlight HEAT/COOL.
Default: HEAT
button to display the heat and cool
selections.
and buttons to select Heat or Cool.
button to accept the highlighted
selection and display the next option.
highlight SETBACK.
and buttons to increase/decrease
the desired setpoint temperature.
Default: 60° F (16° C)
Range: -40° to 248° F (-40° to 120° C)
button to accept the value and display
the menu.
and buttons to
and buttons to
and buttons to
(Mod or Relay)