Makita DTS131 Instruction Manual page 10

For tool with shallow bit hole
A=12 mm Use only these type of bit. Follow the
procedure (1).
B=9 mm
(Note) Bit-piece is not necessary.
For tool with deep bit hole
A=17 mm
To install these types of bits, follow
the procedure (1).
B=14 mm
To install these types of bits, follow
A=12 mm
the procedure (2).
B=9 mm
(Note) Bit-piece is necessary for
installing the bit.
Procedure 1
For tool with normal sleeve
1
► 1 . Bit 2. Sleeve
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the bit.
For tool with one-touch type sleeve
To install the bit, insert the bit into the sleeve as far as
it will go.
2
10 ENGLISH
Procedure 2
In addition to the procedure(1) above, insert the bit-
piece into the sleeve with its pointed end facing in.
2
1
► 1 . Bit 2. Bit-piece 3. Sleeve
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
• When it is difficult to insert the bit, pull the
sleeve and insert it into the sleeve as far as it
will go.
• After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
Hook
► 1 . Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
3
1
2
3