Craftsman G10-0R7G-2SB Manual page 85

F5.08
This group parameters are used to set digital multifunction input terminals
corresponding function
0:No function
1:FWD
2:REV
When operation instruction channels is the terminal control, frequency converter
running commands given by the terminal function.
3:3-line running control
Please refer to description of F5.00.
4:FWD JOG
5:REV JOG
Please refer to description of F8.06-F8.08.
6:Free stop
When the Command is effective,motor will immediately blockade output and coasts to
stop by its mechanical inertia.It should use this way when large inertia load and no
demands to stop time.This way has the same meaning as free stop which F1.08 mention.
7:Malfunction reset
Resets faults that have occurred.It has the same function as STOP/RST .
8:running pause
When this terminal takes effect,inverter decelerates to stop and save current status,
such as PLC,traverse frequency and PID.When this terminal takes no effect,inverter
restores the status.
9:Exterior fault input
Stop the inverter and output an alarm when a fault occurs in a peripheral device.
10:Frequency UP
11:Frequency DW
12:UP/DW clear
HDI terminal function
85
0ÿ^400 00