Maintenance - Makita UH013G Instruction Manual

The chip receiver gathers discarded leaves and makes
clean-up afterward much easier.
Fig.34
To cut a hedge side evenly, cut from the bottom to top.
Fig.35
When trimming to make a round shape (trimming boxwood or rho-
dodendron, etc.), trim from the root to the top for a beautiful finish.
Fig.36

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Cleaning the tool
Clean the tool by wiping off dust with a dry cloth or one
dipped in soapy water and wrung out.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Shear blade maintenance
Before the operation or once per hour during operation,
apply low-viscosity oil (machine oil, or spray-type lubri-
cating oil) to the shear blades.
Fig.37
After operation, remove dust from the shear blades with a wired
brush, wipe it off with a cloth and then apply low-viscosity oil
(machine oil, or spray-type lubricating oil) to the shear blades.
Fig.38
NOTICE:
Do not wash the shear blades in water.
Doing so may cause rust or damage to the tool.
NOTICE:
Dirt and corrosion cause excessive
blade friction and shorten the operating time per
battery charge.
16 ENGLISH