Sécurité; Chapter 0 - Safety Precautions / Precautions De; Securité - GE D8R4 Instructions Manual

Expanded i/o for av-300i drives
Table of Contents

Advertisement

Available languages

Available languages

Chapter 0 - SAFETY PRECAUTIONS / PRECAUTIONS
N
!
OTE
W
! / A
ARNING
TTENTION
-
According to the EEC standards the AV300i and accessories must be used
only after checking that the machine has been produced using those safety
devices required by the 89/392/EEC set of rules.
Drive systems cause mechanical motion. It is the responsibility of the
user to insure that any such motion does not result in an unsafe condition.
Factory provided interlocks and operating limits should not be bypassed
or modified.
-
Never open the device or covers while the AC Input power supply is switched
on. Minimum time to wait before working on the terminals or internal devices
is listed in section 5.11 on Hardware & Quick Start Up Guide.
-
If the front plate has to be removed because the ambient temperature is
higher than 40 degrees, the user has to ensure that no occasional contact
with live parts will occur.
-
Always connect the Drive to the protective ground (PE) via the marked
connection terminals (PE2) and the housing (PE1). Adjustable Frequency
Drives and AC Input filters have ground discharge currents greater than
3.5 mA. EN 50178 specifies that with discharge currents greater than 3.5
mA the protective conductor ground connection (PE1) must be fixed type
and doubled for redundancy.
-
The drive may cause accidental motion in the event of a failure, even if it is
disabled, unless it has been disconnected from the AC input feeder.
-
Selon les normes EEC, les drives AV300i et leurs accessoires doivent être
employés seulement après avoir verifié que la machine ait été produit
avec les même dispositifs de sécurité demandés par la réglementation
6
—————— I/O Expansion card ——————
GEI-100425A
DE SECURITÉ
The terms "Inverter", "Controller" and "Drive" are
sometimes used interchangably throughout the indus-
try. We will use the term "Drive" in this document
Les mots "Inverter", "Controller" et "Drive" sont
interchangeables dans le domaine industriel. Nous
utiliserons dans ce manuel seulement le mot "Drive".
!

Advertisement

Table of Contents
loading

Table of Contents