Huawei B2268H User Manual page 12

LTE TDD B2268H
User Guide
Table 1-1 LED Descriptions (From Left To Right)
LED
PWR/SYS
LINK
LTE RSSI
WLAN/
WPS
PHONE
Issue 01 (2014-01-15)
COLOR STATUS
Green On
Blinking
Red On
Blinking
Off
Green On
Blinking
Off
Green No Signal
LEDS
(RSSI_1,
RSSI_2,
RSSI_3,
RSSI_4,
RSSI_5)
Refer Table 1-2 LTE Signal Strength LED Definition
Please note the ODU presents the same LED behavior as IDU.
Green On
Blinking
Orange Blinking
Off
Green On
Blinking
Orange On
Blinking
Off
Copyright © Huawei Technologies Co., Ltd.
DESCRIPTION
The LTE Device is receiving power and ready for
use.
The LTE Device is booting up.
The LTE Device detected an error while
self-testing, or there is a device malfunction.
The LTE Device is upgrading the firmware.
The LTE Device is not receiving power.
The LTE Device has an LTE connection on the
WAN.
The LTE Device is searching for a frequency
channel or is performing network entry.
The LTE Device does not have an LTE connection
on the WAN.
There are 5 signal LEDs to show the Received
Signal Strength Indication (RSSI) of the LTE
radio connection.
There is no LTE connection.
The wireless network is activated and is operating
in IEEE 802.11 "b", "g" or "n" mode.
The LTE Device is communicating with other
wireless clients.
The LTE Device is setting up a WPS connection.
The wireless network is not activated.
A SIP account is registered for the phone port.
A telephone connected to the phone port has its
receiver off of the hook or there is an incoming
call.
A SIP account is registered for the phone port and
there is a voice message in the corresponding SIP
account.
A telephone connected to the phone port has its
receiver off of the hook and there is a voice
message in the corresponding SIP account.
The phone port does not have a SIP account
1 Introduction
5