Quick Start Guide - Black & Decker BCW27MW Instruction Manual

SET UP & USE
Before First Use
This unit has cycles for wash only; dry only, wash and dry.
This unit uses a condenser to dry and is not vented. Drying times will take longer than
a vented dryer.
CAUTION: The temperature inside the unit can get very hot during dry cycles.
NOTE: To avoid long drying times and best performance, do not load the tub more
than ¾ full of dry clothes for wash cycles. The tub should not be loaded
more than ½ full for wash/dry cycles and dry cycles.
DO NOT OVERLOAD
Before washing clothes for the first time, the washing machine should be operated
without clothing added.
1. Connect power source and water supply.
2. Put a small amount of detergent into the dispenser and close the dispenser.
3. Close the Door.
4. Select a wash cycle using the dial.
5. Press ON/OFF.
6. Press the Start/Pause button.
NOTE: If water leaks while water is being supplied or drained, check the water
connections.
If the washer rocks and vibrates excessively, level your washer again.

QUICK START GUIDE

Default settings can be changed. See USING THE CONTROL PANEL section for more
details.
1. Add HE detergent to the detergent dispenser according to detergent
manufacturer's instructions. HE detergent pods can be added to the wash tub
before adding clothes.
Add optional pre-wash and/or fabric softener to the detergent dispenser.
Load clothing, maximum ¾ full for a wash only cycle, maximum ½ full of wet
2.
clothes for a wash/dry cycle or a dry only cycle.
3. Close the Door.
NOTE: Unit will not start with the door open.
4. Press ON/OFF to power on the unit.
5. Turn the selector dial to a cycle with a
6. Continue to touch the DRY key
Normal Dry
7. Press the Start/Pause button.
For more details on cycles and default setting refer to the wash program chart.
or Extra Dry . The corresponding symbol will illuminate.
such as PERM PRESS.
repeatedly to select Gentle Dry
ENGLISH
,
Page 7