Black & Decker BCW27MW Instruction Manual page 11

SET UP & USE
6. Temp
Press Temp continuously to scroll through the selections: Hot+, Hot, Warm, Eco, Cold.
The selected temperature will be illuminated on the LED Display.
7. Spin
Press Spin continuously to scroll through the selections: Highest, High, Med, Low, No
Spin. The selected spin speed will be illuminated on the LED Display.
8. Extra Rinse
Press and hold Temp and Spin at the same time to add approximately 17 minutes
extra rinse time. The extra rinse symbol will illuminate.
9. Soil
Press Soil continuously to scroll through the selections: Heavy (For heavily soiled
clothes), Med, Light. The selected soil level will be illuminated on the LED Display.
10. Mute
Press the Soil button 3 seconds to mute the buzzer at the end of the cycle. Press
again for 3 seconds to unmute the buzzer.
11. Dry
Press the Dry button continuously to select Gentle Dry
Dry . This option is available for Normal/Cotton, Heavy Duty, Sportswear and Dry
cycles.
DRY only settings can be selected using the selector dial.
Auto Dry
Uses a 12 minute spin cycle and 45 minute cool air cycle.
Timed Dry
Timed Dry programs include a 12 minute spin and 25 minute cool cycle. After
selecting timed dry using the selector dial, press the DRY button on the control panel
to select Gentle Dry
(3:20 minutes).
It is recommended to dry in multiple, smaller loads to allow for better performance.
NOTE: It is not necessary to disconnect water supply or remove water inlet hoses
during dry cycles. This is a ventless unit that releases moisture.
The dryer is equipped with a door-locking safety feature to ensure safe
temperatures and avoid burns and other safety hazards. The door will lock
a few minutes after the wash cycle begins depending on water level. It will
remain LOCKED during the cycle until the unit reaches a safe temperature.
After a safe temperature is reached, the door should open and function
normally.
12. Child Lock
Use this option to disable the controls except for the ON/OFF. This feature can
prevent children from changing cycles. The washer can only be locked during a cycle.
To activate this function after starting the washer, press and hold the Delay and Temp
buttons at the same time for 3 seconds. There will be an audible sound and the child
lock indicator light will turn on. To cancel this function select the Temp and Program
buttons again.
(59 minutes), Normal Dry
, Normal Dry
(1:29 minutes), or Extra Dry
ENGLISH
or Extra
Page 11