Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Black & Decker BDAG710
Summary of Contents for Black & Decker BDAG710
- Page 1 BDAG710 www.blackanddecker.eu...
- Page 2 English (original instructions) ..................5...
- Page 5 English (original instructions) Your BLACK+DECKER BDAG710 angle grinder has been 3. Personal safety designed for grinding and cutting metal and masonry using a. Stay alert, watch what you are doing and use common sense when operating a power tool. Do the appropriate type of cutting or grinding disc.
-
Page 6: Kickback And Related Warnings
English (original instructions) e. Maintain power tools. Check for misalignment or If power tool or accessory is dropped, inspect for damage or install an undamaged accessory. After binding of moving parts, breakage of parts and any inspecting and installing an accessory and run the other condition that may affect the power tools power tool at maximum no-load speed for one minute. -
Page 7: Safety Warnings Specific For Grinding And Abrasive Cutting-Off Operations
English (original instructions) Pinching or snagging causes rapid stalling of the rotating ● Always use undamaged wheel flanges that are of accessory which in turn causes the uncontrolled power tool to correct size and shape for your selected wheel. be forced in the direction opposite of the accessory’s rotation Proper wheel flanges support the wheel thus reducing at the point of the binding. - Page 8 English (original instructions) ● If the use of a guard is recommended for wire Warning! To reduce the risk of injury, the user brushing, do not allow any interference of the must read the instruction manual. wire wheel or brush with the guard. Wire wheel or brush may expand in diameter due to work load and Wear safety glasses or goggles when operating centrifugal forces.
- Page 9 English (original instructions) Fitting the side handle ● Allow the tool to reach full speed before touching the tool to the work surface. ● Screw the side handle (4) into one of the mounting holes ● Apply minimum pressure to the work surface, in the tool.
- Page 10 English (original instructions) Areas where paint removal is occurring should be Using sanding backing pads (fig. H) sealed with plastic sheeting of 4 mils thickness. Always choose the proper grit sanding discs for your Sanding should be done in a manner to reduce tracking application.
-
Page 11: Maintenance
English (original instructions) Warning! Use extra care when working over an ● Once a cut is begun and a notch is established in the edge, as a sudden sharp movement of grinder may workpiece, do not change the angle of the cut. Changing be experienced. -
Page 12: Troubleshooting
English (original instructions) Warning! No connection is to be made to the Type 41 Cutting Wheels earth terminal. Follow the fitting instructions supplied with good quality plugs. Recommended fuse: 13 A. Troubleshooting Problem Possible cause Possible solution Type 41 guard Type 41 guard Unit will Cord not... -
Page 13: Technical Data
English (original instructions) Technical data EC declaration of conformity MACHINERY DIRECTIVE BDAG710 Type 1 Input voltage Power input Rated speed 12000 BDAG710 Angle grinder Disc bore Black & Decker declares that these products described under “technical data” are in compliance with: Max disc thickness 2006/42/EC, EN 60745-1:2009 + A11:2010;... - Page 16 Australia Black & Decker (Australia) Pty. Ltd. Tel. 03-8720 5100 20 Fletcher Road, Mooroolbark, 03-9727 5940 Victoria, 3138 New Zealand Black & Decker Tel. +64 9 259 1133 5 Te Apunga Place +64 9 259 1122 Mt Wellington Aukland 1060 United Kingdom &...