Table of Contents
Advertisement
installation
4. Stand the unit. Place the bottom hole of the door
onto the bottom hinge pin. Insert the upper hinge
pin into the upper hole of the door. Screw the upper
hinge tightly. Screw also the other side tightly.
Ensure the door is aligned horizontally and
vertically, so that the seals are closed on all
sides before finally tightening the hinge.
5. Put back the top cover. Tighten the 2 screws at the
back of the top cover.
6. Transfer the door handle to the other side of the door
accordingly. Remove the 2 door screw hole covers
from the other side of the door and swap their position
with the door handle.
cleaning before use
Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water
using a sponge or cloth. Wipe completely dry before replacing the drawers. Clean the exterior of
the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time to
settle.
before using your unit
Before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is working
properly and to allow it time to fall to the correct temperature. Your unit should not be overfilled.
10
Advertisement
Table of Contents
