Installing The Water Tank; Cleaning Before Use; Before Using Your Unit - Kenwood KSBSDB15 Installation Instructions Manual

installation

installing the water tank

• Insert the valve of the water tank into the hole of
the water dispenser and push down the water tank
to attach securely with the water dispenser.
• To remove the water tank, hold firmly on both sides
and bottom of the water tank then push up.
Be careful not to press on the valve.
• Make sure the rubber seal inside the hole
is in proper position before installing the
water tank. This is because the rubber
seal may turn inside out when removing
the water tank.
• A tiny part of the rubber seal will appear
torn. This is not a damage. On the
contrary, it helps to prevent the rubber
seal from turning inside out when
removing the water tank.

cleaning before use

Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water
using a sponge or cloth. Wipe completely dry before replacing the drawers. Clean the exterior of
the unit with a damp cloth.
If you require more information refer to the Cleaning section.
• Before Plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the unit.
• Before Turning On!
Do not turn on until two hours after moving the unit. The coolant fluid needs time to
settle.

before using your unit

before placing any food in your unit, turn it on and wait for 24 hours, to make sure it is working
properly and to allow it time to fall to the correct temperature. Your unit should not be overfilled.
Valve
7