NETGEAR WNR834 Setup Manual page 33

– Configure your router to spoof your computer's MAC address. On the Basic Settings
screen in the Router MAC Address section, select "Use this Computer's MAC Address"
and click Apply. Then restart your network in the correct sequence (see
Checklist" on page
Troubleshooting PPPoE
If you are using PPPoE, try troubleshooting your Internet connection.
To troubleshoot a PPPoE connection:
Log in to the wireless router.
1.
Select Router Status under Maintenance on the main menu.
2.
Click Connection Status. If all of the steps indicate "OK," then your PPPoE connection is up
3.
and working.
If any of the steps indicate "Failed," you can attempt to reconnect by clicking Connect. The
wireless router will continue to attempt to connect indefinitely.
If you cannot connect after several minutes, you may be using an incorrect Service Name,
User Name or Password. There also may be a provisioning problem with your ISP.
Unless you connect manually, the wireless router will not authenticate using
PPPoE until data is transmitted to the network.
Troubleshooting Internet Browsing
If your wireless router can obtain an IP address but your computer is unable to load any web pages
from the Internet, check the following:
• Your computer may not recognize any DNS server addresses. A DNS server is a host on
the Internet that translates Internet names (such as www addresses) to numeric IP addresses.
Typically, your ISP will provide the addresses of one or two DNS servers for your use. If you
entered a DNS address during the wireless router's configuration, restart your computer.
Alternatively, you can configure your computer manually with a DNS address, as explained in
the documentation for your computer.
•
Your computer may not have the wireless router configured as its default gateway.
Reboot the computer and verify that the wireless router address (192.168.1.1) is listed by your
computer as the default gateway address.
Troubleshooting
25).
"Basic Setup
29