Download Print this page

Breville Smart Dry Ultimate LAD500 Instruction Book page 11

Hide thumbs Also See for Smart Dry Ultimate LAD500:

Advertisement

1. Locate the continuous drainage outlet
on the back, right hand side of the
dehumidifier, underneath the air inlet grille.
Remove the plug and insert one end of the
hose over the connection outlet, pushing in
as far as possible.
2. As the drainage is dependent on gravity for
the dehumidifier to drain correctly, no part
of the hose should sit higher than the hose
connection outlet.
3. Place the other end of the hose into a
water drain, being careful that it cannot
inadvertently come loose when water starts
to drain.
4. The water will drain from the dehumidifier
directly through the hose.
WARNING
Ensure the hose is secure in both the hose
connection and the drainage outlet and into
the water drain.
NOTE
Ensure the plug is placed back onto the
continuous drainage outlet securely when
continuous drainage is not in use.
LAD500_ANZ_IB_C19.indd 11
PUMP DRAINAGE
Pump drainage allows the dehumidifier
to empty the water tank using the hose to
pump the water out of the tank when full.
This is suitable for homes where there is
a drain available within the vicinity of the
dehumidifier. It is also suitable for homes
that have drainage sources higher than the
dehumidifier, such as a sink drain, as the pump
does not rely on gravity to empty the water
Pull out the plug
tank. Ensure the hoses (included) are properly
inserted before turning on the dehumidifier.
Note, the pump suction hose can already be
found in the unit, secured in place.
1. Pull the water tank half way out from the
2. Ensure that one end of the 20cm pump
3. Locate the pump suction joint on the
4. Fit the water tank back into the
back of the dehumidifier.
suction hose is in the water tank, through
the slot located in the tank lid (see
illustration below) and that it hits the
bottom of the tank.
The pump suction
hose is inserted into
the water.
right hand side between the tank and the
dehumidifier body. Ensure the other end of
the pump suction hose is securely over the
suction joint.
The other end is connected
to the suction joint.
dehumidifier, ensuring both ends of the
20cm hose piece remain securely in place.
11
8/4/19 1:38 pm

Advertisement

loading