Filter Cleaning And Replacement - Honeywell HWM6530I User Manual

! WARNING: Wear protection mask when the tank needs to be emptied.

FILTER CLEANING AND REPLACEMENT

HEPA Filter
1. Filters need to be cleaned or replaced from time to time. Suction performance can be
maintained with the Filter Cleaning System. (See Figure 5 and 6) Eventually filters will need to
be washed or become worn and need to be replaced. To clean or replace the filter:
a. Turn switch off (0) and unplug power cord from the electrical outlet.
b. Remove hose from suction inlet.
c. Remove head from the tank by pulling gently on the clamps on the vacuum head, turn
the head upside down.
d. See Figure 8. Using a Phillips screw driver, remove the 4 screws holding the filter frame
to the head (A).
e. See Figure 9. Remove the filter frame (A) and the filter (B).
f. Insert a new filter into the filter frame and place it on the head.
g. Replace the 4 screws. Do not over tighten the screws.
h. Be sure that the filter is properly fixed and the sealing between head and filter frame is
secure.
i. Attach head to the tank, ensuring they are securely clamped together.
Use only a factory authorized replacement filter. To order a filter, contact Customer Service at
866-814-4103 or service@producteersusa.com.
Never machine wash or machine dry filters.
Figure 8
Figure 9
9