Draytek Vigor2866 Series Quick Start Manual page 11

2.2 Vigor286 5ac/Vigor2866ac
2.2 Vigor286 5ac/Vigor2866ac
LED
ACT
WAN2
QoS
USB
DSL
WCF
2.4G/5G
DMZ
LED on Connector
Left
WAN2
LED
/ P6
Status Explanation
Off The router is powered off.
Blinking The router is powered on and running
normally.
On Internet connection is ready.
Off Internet connection is not ready.
Blinking The data is transmitting.
On The QoS function is active.
Off The QoS function is inactive.
On USB device is connected and ready for use.
Off No USB device is connected.
Blinking The data is transmitting.
On The router is ready to access Internet
through DSL link.
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
On The Web Content Filter is active. (It is
enabled from Firewall >> General Setup).
Off WCF is disabled.
2.4G/5G: Wireless access point with
On
bandwidth of 2.4GHz/5GHz is ready.
WLAN: Wireless access point is ready.
Off Wireless function is disabled.
It will blink slowly while wireless traffic goes
Blinking
through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and
will return to normal condition after two
minutes. (You need to setup WPS within 2
minutes.)
On The DMZ function is enabled.
Off The DMZ function is disabled.
Blinking The data is transmitting.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
5