Restoring The Web Console Or Remote Console Settings; Bios Resetting - Hitachi Compute Rack 220S Replacement Manual

Restoring the Web console or Remote Console settings

The server management settings as the Web console and the Remote Console
application will be lost when a motherboard is replaced.
For this reason, if either the Web console or the Remote Console application is
used, restore the server management settings from the Web console.
The server management settings should be backed up and kept in advance in
preparation for a failure.
For the backup and restoration of server management settings, see Hitachi
Compute Rack 220S Remote Management User's Guide.

BIOS resetting

System BIOS or RAID BIOS settings might be returned to the factory defaults
when a motherboard or a RAID card is replaced.
In this case, reset the BIOS settings using the BIOS setup utility, such as "Setup
menu" or "MegaRAID WebBIOS".
If you change the BIOS settings from the factory defaults, note down all the
changed setting values after replacement in case of failure.
For system BIOS and RAID BIOS settings, see Hitachi Compute Rack 220S BIOS
Guide.
Depending on the fault status, the BMC network settings of the
management network interface might be returned to the factory
defaults. In this case, reconfigure the BMC network.
Similarly, BIOS settings of a PCI card might be returned to the factory
defaults when replace a PCI card.
For the BIOS settings of an optional PCI card, see Optional PCI card
instruction manual.
Setup after maintenance
Hitachi Compute Rack 220S CRU Replacement Guide
5-3