Table of Contents
Advertisement
OM-CP-RFCURRENT2000A
Channel Programming
The OM-CP-RFC1000-EXT transmits data on the 2.4GHz band and is programmed by default on channel 11.
Each Omega Wireless Data Logger and OM-CP-RFC1000-EXT has a set of dip switches with which the channel
may be programmed.
Different wireless channels may be used to create multiple networks in one area, or to avoid wireless interference
from other devices. Any Omega data logger or OM-CP-RFC1000-EXT that is on the same network is required to
use the same channel. If all of the devices are not on the same channel, the devices will not communicate with
one another.
The images below show the orientations available of the switches for each channel. Channel 26 (all switches in the
up position) is not supported.
Channel 11
Channel 17
Follow the instructions below to configure the channel settings of the OM-CP-RFC1000-EXT.
1. To program the channel on an OM-CP-RFC1000-EXT, first unplug the OM-CP-RFC1000-EXT.
2. Use a Phillips head screwdriver to unscrew the enclosure.
3. Find the dip switches located on the front of the PCB circuit board.
4. Change the dip switches to match the the desired channel using the diagram above.
5. Screw the enclosure back together and reconnect the OM-CP-RFC1000-EXT.
Channel 12
Channel 13
Channel 18
Channel 19
Channel 23
Channel 24
Channel 14
Channel 15
Channel 20
Channel 21
Channel 25
Channel 26
(not supported)
Channel 16
Channel 22
Close-up
Advertisement
Table of Contents
