To remove the dust cup set, remove the bit while pulling
the chuck cover in the direction of the arrow.
1
2
► 1. Bit 2. Chuck cover
Hold the root of dust cup and pull it out.
NOTE: If you connect a vacuum cleaner to the dust
cup set, remove the dust cap before connecting it.
1
► 1. Dust cap
NOTE: If the cap comes off from the dust cup, attach
it with its printed side facing up so that groove on the
cap fits in the inside periphery of the attachment.
Tool hanger
Optional accessory
WARNING:
and screw.
WARNING:
tool hanger only.
WARNING:
check for damages, cracks or deformations, and
make sure that the screw is tightened.
CAUTION:
Install or remove the tool hanger
on a stable table or surface.
The tool hanger is intended for connecting the lanyard
(tether strap). To install the tool hanger to the tool,
follow the steps below.
1.
Disconnect the plug from the power source.
2.
Insert the projections of the tool hanger into the
holes on the tool.
3.
Tighten the screws firmly.
► 1. Tool hanger 2. Hole 3. Projection 4. Screw
11 ENGLISH
Do not use damaged tool hanger
Use the screw provided with the
Before using the tool hanger,
2
1
3
4