Function Code Descriptions (01 Thru 79) - GE Fuji Electric AF-300 MICRO-SAVER II Instructions Manual

TABLE 6: Function Codes (Cont'd)
Function Code Numbers Followed by Function Descriptions
* Function can be changed while the Drive is operating.
Basic Functions Basic Functions (cont'd)
Page 6 –
–
66 Electronic Overload 2 22
Selection
67 Electronic Overload 22
Setting 2
68 *Slip Compensation 22
69 Torque Vector Control 23
70 Motor HP Capacity 1 23
71 Rated Current 1 23
72 No-load Current 1 23
73 Rated Current 2 23
74 Automatic Tuning 24
75 Motor 1 (%R1 Setting) 24
76 Motor 1 (%X Setting) 25
77 *Torque Limiting Response 25
at Constant Speed
78 *Torque Limiting Response 25
During Acceleration/
Deceleration
79 Option Card Selection 25
Basic Functions (cont'd)
Page 6 – Page 6 –
5-11
LED
Data
Display Setting Description
Section 6
FUNCTION CODE DESCRIPTIONS
Basic Functions
NOTE: * = Function can be changed while Drive is operating.
LED
Data
Display Setting Description
F_00 DATA PROTECTION
This Function protects the data setting from
accidental changes.
0 Data Changeable
1 Data Protected
To change the Data Protection Setting,
simultaneously press the
STOP key and either the
F_01 FREQUENCY COMMAND
The frequency reference setting method can be selected.
0 Using the Keypad Panel
1 Using analog signal input
Note: The frequency setting will be the sum of the
values at terminal 12 (0 to 10 VDC) and terminal C1
(4 to 20mA dc).
2 UP/DOWN Control
Output frequency can be increased or decreased by signal
input to the terminals X1 and X2.
The adjustable range is from minimum frequency to max
frequency. If the terminals X1-CM is held closed, output
frequency increases by F63 (2nd acceleration time). When
the terminals X2-CM is held closed, output frequency
decreases by F64 (2nd deceleration time). The rotation
direction can not be changed. The rotation direction
depends on input to the terminal FWD or REV.
*Default value = 0
Factory setting for NEMA1 = 1. Will reset to 0 when default is selected
Factory Customer
Setting Setting
Factory Customer
Setting Setting
0
or key.
0/1*
and keys
6-1