Specify The Ip Addresses That The Router Assigns - NETGEAR Nighthawk RAX80 User Manual

• Both. The router broadcasts its routing table periodically and incorporates
information that it receives.
• Out Only. The router broadcasts its routing table periodically.
• In Only. The router incorporates the RIP information that it receives.
b. Select the RIP version:
• Disabled. This is the default setting.
• RIP-1. This format is universally supported. It is adequate for most networks, unless
you are using an unusual network setup.
• RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the routing
data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses multicasting.
7. Click the Apply button.
Your settings are saved.
If you changed the LAN IP address of the router, you are disconnected when this change takes
effect.
8. To reconnect, close your browser, relaunch it, and log in to the router.

Specify the IP addresses that the router assigns

By default, the router acts as a Dynamic Host Configuration Protocol (DHCP) server. The router
assigns IP, DNS server, and default gateway addresses to all computers connected to the LAN.
The assigned default gateway address is the LAN address of the router.
These addresses must be part of the same IP address subnet as the router's LAN IP address.
Using the default addressing scheme, define a range between 192.168.1.2 and 192.168.1.254,
although you can save part of the range for devices with fixed addresses.
To specify the pool of IP addresses that the router assigns:
1. Launch a web browser from a computer or mobile device that is connected to the router
network.
2. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified the first time that you
logged in. The user name and password are case-sensitive.
The BASIC Home page displays.
Manage Network Settings
Nighthawk AX8 8-Stream AX6000 WiFi Router
53 User Manual