Makita RP1111C Instruction Manual page 8

1
Fig.10
► 1. Feed direction 2. Bit revolving direction
3. Workpiece 4. Straight guide
Straight guide
Optional accessory
The straight guide is effectively used for straight cuts
when chamfering or grooving.
Fig.11
1. Insert the guide bars into the holes in the tool
base.
2. Adjust the distance between the router bit and
the straight guide. At the desired distance, tighten the
thumb screws to secure the straight guide in place.
Fig.12
► 1. Thumb screw 2. Straight guide
2
3
4
1
3. When cutting, move the tool with the straight guide
flush with the side of the workpiece.
If the distance between the side of the workpiece and
the cutting position is too wide for the straight guide, or
if the side of the workpiece is not straight, the straight
guide cannot be used. In this case, firmly clamp a
straight board to the workpiece and use it as a guide
against the router base. Feed the tool in the direction of
the arrow.
Fig.13
Templet guide
Optional accessory
The templet guide provides a sleeve through which the
router bit passes, allowing use of the router with templet
patterns.
Fig.14
1. Loosen the screws on the base, insert the templet
guide and then tighten the screws.
2
2
Fig.15
► 1. Screws 2. Templet guide
8 ENGLISH
1