Related Manuals for Zenith ChillMaster
Summary of Contents for Zenith ChillMaster
- Page 1 Installation instructions & user manual Zenith Freestanding Chilled Water Instant filtered drinking water. AFFIX PRODUCT LABEL HERE 806310NZ v1.06 08.19 CW ChillMaster & EconoMaster...
-
Page 2: Warnings And Precautions
4. The power cord and general power outlet must be in a safe and accessible position after installation. 5. If the power supply cord is damaged it must be replaced by a Zenith Service Provider or a qualified electrician. 6. Do not remove the cover of the appliance under any circumstances without first isolating the appliance from the power supply. -
Page 3: Rear View
• Connect a cold water supply to the half inch BSP male inlet at the back of the unit (Fig.2). • Connect a drain to the 40 mm PVC female outlet (ChillMaster, EconoMaster) or male outlet (SiteMaster) at the back of the unit. -
Page 4: Operation
If inlet supply pressure is greater than 700 kPa, a pressure limiting valve (PLV) should be fitted as per the manufacturer’s instructions (only for EconoMaster/SiteMaster. The ChillMaster already has a PLV internally fitted). If excessive water flow is still a problem, tighten the Cartridge inside the Bubbler, as... -
Page 5: Maintenance
Warning: Not changing filter cartridges when required may cause the water to become biologically unsafe. If the Zenith ChillMaster is switched off for a long period of time (e.g. more than 2-3 days), run water through the chilled water outlet for at least 5 minutes before consumption. - Page 6 Before calling for service, check that both the water and electricity supplies are turned ‘ON’ and OK. Call a licenced electrician, plumber, or Zenith free call in New Zealand on 0800 558 055, for assistance, service, spare parts, or enquiries.
-
Page 7: Troubleshooting
Ensure that all electrical connections to the unit are secure and that the unit has had adequate time to cool down. Call a licenced electrician, plumber, or Zenith free call in New Zealand on 0800 558 055, for assistance, service, spare parts, or enquiries. - Page 8 Products described in this publication are manufactured under one or more patents and further patent applications are pending. As Zenith’s policy is one of continuous product improvement, changes to specifications may be made without prior notice. Images in this booklet have been modified and may not be true representations of the finished goods.