Grizzly G0771Z Manual page 70

4. Measure gap between fence and table top at
front and rear of fence.
— If gap is approximately
front of table to back (see Figure 120),
then no additional adjustments are neces-
sary. Proceed to Fence Handle Clamping
Pressure below.
— If gap is uneven, or if fence height is not
approximately
1
tinue with Step 5.
/ " Gap (Side View)
1
16
Table
Front Set
Screws
(1 of 2)
Figure 120. Example of even gap between fence
and table approximately
5.
Remove fence assembly and lay it upside
down.
6.
Remove fence assembly cap as shown in
Figure 121, then loosen inner and outer jam
nuts that secure bearing shaft.
Note: Wrench clearance for inner jam nut
is tight inside fence assembly. If necessary,
hold inner jam nut with wrench and twist
bearing shaft to loosen.
Bearing Shaft
Outer
Jam Nut
Figure 121. Rear adjustment area for leveling
fence.
Model G0771Z (Mfd. Since 01/21)
⁄ " and even from
1
16
⁄ " above table, then con-
16
Fence
Rear
Bearing
Shaft
⁄ " front to back.
1
16
Assembly Cap
Roller
Bearing
7. Re-install fence assembly.
8. Reach inside fence and adjust height of bear-
ing shaft. Turn shaft clockwise to decrease
shaft height; turn shaft counterclockwise to
raise shaft height.
9.
When satisfied with position of bearing shaft,
remove fence and tighten inner and outer
jam nuts. Keep roller bearing parallel with
rear fence rail.
10. Re-install fence. Repeat Steps 4–9 until gap
between table and fence is approximately
and even from front to back of table.
Fence Handle Clamping Pressure
Remove fence and lay it upside down.
1.
Loosen knurled lock nut (see Figure 122).
2.
Knurled Lock Nut
and Set Screw
Figure 122. Set screw for adjusting fence handle
clamping pressure.
Adjust set screw clockwise to increase clamp-
3.
ing pressure of lock handle or counterclock-
wise to decrease clamping pressure.
Tighten knurled lock nut.
4.
Re-install fence and check clamping pres-
5.
sure of lock handle.
Repeat Steps 1–5 as necessary to achieve
6.
desired results.
⁄ "
1
16
-67-