Grizzly G0771Z Manual page 25

12. Install table/dado insert in table throat (see
Figure 24). Check to make sure it is flush
and adjust if necessary (see Table/Dado
Insert Adjustment on Page 70 for more
information).
Figure 24. Table insert installed.
13. Install handwheels on shafts, making sure
notch in each wheel fits over pin on each
shaft, and secure with star knobs, as shown
in Figure 25.
Notch
Figure 25. Handwheel installed.
14. Install saw blade as instructed in Blade
Installation on Page 30.
-22-
15. Raise motor slightly, using blade height
Figure 26. Location of styrofoam block to be
16. Place fence on front fence rail, as shown in
Star Knob
handwheel, and remove styrofoam block
that supports motor during shipping (see
Figure 26).
Remove
removed.
Figure 27). Press handle down to lock fence
in position.
Front
Fence
Rail
Figure 27. Fence installed on front rail.
Model G0771Z (Mfd. Since 01/21)
Fence