Related Manuals for Makita maktec MT902
Summary of Contents for Makita maktec MT902
- Page 1 INSTRUCTION MANUAL Angle Grinder MT902 MT903 011097 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model MT902 MT903 Depressed center wheel diameter 180 mm 230 mm Spindle thread Rated speed (n)/No load speed (n 8,500 min 6,600 min Overall length 466 mm Net weight 5.4 kg 5.7 kg Safety class • Due to our continuing program of research and development, the specifications herein are subject to change without notice. •... -
Page 3: Grinder Safety Warnings
If operating a power tool in a damp location is accessories, or storing power tools. Such unavoidable, use a residual current device preventive safety measures reduce the risk of (RCD) protected supply. Use of an RCD reduces starting the power tool accidentally. the risk of electric shock. - Page 4 The rated speed of the accessory must be at into the spinning accessory. least equal to the maximum speed marked on 12. Never lay the power tool down until the the power tool. Accessories running faster than accessory has come to a complete stop. The their rated speed can break and fly apart.
- Page 5 e) Do not attach a saw chain woodcarving carefully re-enter the cut. The wheel may bind, blade or toothed saw blade. Such blades create walk up or kickback if the power tool is restarted in frequent kickback and loss of control the workpiece.
-
Page 6: Functional Description
24. Do not leave the tool running. Operate the tool FUNCTIONAL DESCRIPTION only when hand-held. 25. Do not touch the workpiece immediately after operation; it may be extremely hot and could CAUTION: burn your skin. Always be sure that the tool is switched off and •... - Page 7 For tool with the lock on and lock-off switch 1. Wheel guard To prevent the switch trigger from accidentally pulled, a 2. Screw lock lever is provided. 3. Bearing box To start the tool, push in the lock lever (in the A direction) and then pull the switch trigger (in the B direction).
-
Page 8: Operation
Operation with wire cup brush (optional OPERATION accessory) WARNING: CAUTION: It should never be necessary to force the tool. The • Check operation of brush by running tool with no • weight of the tool applies adequate pressure. load, insuring that no one is in front of or in line with Forcing and excessive pressure could cause brush. -
Page 9: Maintenance
Thread wire wheel brush onto spindle and tighten with For Australia and New Zealand the wrenches. Installing or removing abrasive cut-off wheel / When using wire wheel brush, avoid applying too much diamond wheel (optional accessory) pressure which causes over bending of wires, leading to premature breakage. - Page 10 1. Brush holder 2. Screwdriver 011106 To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts.
- Page 12 Makita Corporation www.makita.com 884970B9...