Yamaha DRIVE 2 SUPER HAULER 2019 Owner's/Operator's Manual page 41

NOTICE
Charge only 48-volt battery
systems manufactured by Trojan
Battery Company. Damage to the
charger and batteries may result if
this charger is used on the wrong
battery type.
Visually and manually inspect to
verify that the DC output cord,
plug and battery charging
receptacle are in good working
condition before each and every
use. Do not use the charger under
any of the following conditions:
The DC charging receptacle does
G
not grip the DC cord set plug
tightly, is loose or does not make
a good electrical connection.
The DC cord set plug or
G
charging receptacle feels hotter
than normal.
The DC cord set plug or
G
charging receptacle contacts are
bent, corroded, or are dark or
bluish in appearance.
The DC cord set plug, cords,
G
receptacle or equipment-
charging wiring are cut, worn,
broken or have any exposed
conductors.
The DC cord plug, cords, charger
G
or receptacles are damaged or
distressed in any way.
Using the charger with any of the
above symptoms could result in a
fire, property damage or personal
injury.
J2F
MAINTENANCE
Do not disconnect the DC cord set
plug from the DC charger
receptacle when the charger is on.
If the charger must be stopped,
first disconnect the AC power
supply cord from its AC outlet, and
then disconnect the charger DC
cord set plug from the DC charger
receptacle.
Whenever removing AC or DC cord
set plugs from receptacles, pull
from the plug body and not from
their respective cords.
The instructions printed on the
charger (shown below) are for daily
reference. The charger is factory
preset for use with Trojan 48-volt golf
car batteries.
8
8-13