Black & Decker 4500 Series Manual page 12

Step 10 (Assemble the side burner)
a) Open the side burner lid and place the side burner frame
(R) on the right side table. Make certain the venturi tube
is connected properly with the valve.
b) Align the holes on the side burner frame (R) with the
holes on the right side table. Insert one M4x10 bolt
(CCC) with one M4 spring washer (GGG) and one M4
flat washer (FFF) into each pre-drilled hole.
c) Go back to tighten all of the bolts using the screwdriver
provided.
d) Insert the ignition cable onto the electrode.
e) Close the lid.
Step 12 (Assemble the grease panel with grease panel
stopper)
a) Place the grease panel assembly into the firebox from the
back.
b) Button up the grease panel stopper (V) on the firebox. Align
the hole on the grease panel stopper with the hole on the
firebox. Insert one M6x15 bolt (BBB) with one M6 flat washer
(DDD) into the pre-drilled hole.
c) Tighten the bolts using the screwdriver provided.
JXG4604SS
Owner's Manual
Step 11 (Assemble the grease panel with tank
heat insulator and grease cup support)
a) Loosen the pre-installed bolts on the grease
panel (S) and allow
from the grease panel
b) Align the holes on the tank heat insulator (U) and
the holes on the grease cup support (T) with the
bolts extended from the grease panel.
c) Tighten the bolts using the screwdriver provided.
11
bolt's length to extend
1/4