Black & Decker 4500 Series Manual page 11

(Assemble the side tables with body assembly)
Step 8
a) Loosen the bolts (pre-installed) on the right side of body
assembly and allow
body assembly.
b) Align the holes on the right side table (O) with the bolts
extended from the right side of body assembly. Push
down the right side table until it locks into place.
c) Align the holes on the right side table with the holes of
body and cart assembly.
d) Insert one M6x15 bolt (BBB), one M6 spring washer
(EEE) and one M6 flat washer (DDD) into each
pre-drilled hole. Tighten bolts by hand until secure.
e) Repeat the procedure for the right side table (N) with
body assembly.
f) Go back and tighten all bolts using the screwdriver
provided.
JXG4604SS
Owner's Manual
bolt's length to extend from the
1/4
Step 7 (Assemble the body assembly with cart assembly)
a) Unpack the regulator/ hose assembly (located underneath
the firebox) prior to assembling the grill body to the cart. Pull
out the regulator/hose to the cart side panel then go ahead to
this step.
b) Put the body assembly (M) on the top of cart assembly.
c) Align the holes on the top of cart right side panel with the
holes on the right of body assembly.
d) Insert one M6x15 bolt (BBB) with one M6 spring washer
(EEE) and one M6 flat Washer (DDD) into each pre-drilled
hole. Tighten the bolts by hand until secure.
e) Repeat the procedure for the left end assembly.
f) Go back to tighten all the bolts using the screwdriver provided.
Step 9 (Knob and knob seat assembly)
a) Align the holes on the knob seat (P) with the holes on the
side shelf and the side burner valve. Screw one M4X10
bolt (CCC) with one M4 flat washer (FFF). Tighten the
bolts using the screwdriver provided.
b) Insert the knob (Q) onto the valve shaft.
10