For Vigor2910G - Draytek Vigor 2910 Quick Start Manual

1 . 1 . 2 F o r V i g o r 2
1 . 1 . 2 F o r V i g o r 2
L E D E x p l a n a t i o n
L E D E x p l a n a t i o n
ACT DMZ QoS Attack WLAN Printer
LED
ACT (Activity)
DMZ
QoS
Attack
WLAN
Printer
WAN(W1-W2)
LAN (P1, P2, P3,
P4)
C o n n e c t o r E x p l a n
C o n n e c t o r E x p l a n
Printer PWR
Interface
Printer
PWR
ON/OFF
LAN P4 – P1
W2/W1
Factory Reset
9 1 0 G
9 1 0 G
WAN
/
W1 W2 P1
Status Explanation
Blinking The router is powered on and running properly.
The router is powered off.
Off
On DMZ Host is specified in certain site.
On The QoS function is active.
Off The QoS function is inactive.
On DoS Defense function is active.
Blinking An attack is detected.
On Wireless access point is ready.
Blinking Wireless traffic goes through.
Off Wireless access point is turned off.
On The USB interface printer is ready.
Orange A normal 10Mbps WAN link is ready.
Green A normal 100Mbps WAN link is ready.
Blinking Ethernet packets are transmitting.
Orange A normal 10Mbps connection is through its corresponding
port.
Green A normal 100Mbps connection is through its corresponding
port.
Blinking Ethernet packets are transmitting.
a t i o n
a t i o n
P4
Description
Connecter for a USB printer.
Connecter for a power adapter with 12-15VDC.
Power Switch.
Connecters for local networked devices.
Connecter for accessing Internet with the ADSL,ADSL2/2+ line
Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and keep for
more than 5 seconds. When you see the ACT LED begins to blink rapidly than
usual, release the button. Then the router will restart with the factory default
configuration.
LAN
P2 P3 P4
P3 P2 W1
P1/W2
3
Factory
Reset