Syslog Transmission Configuration - Panasonic GA-ML Series Manual

3.5.3.

Syslog Transmission Configuration

Press G (command) on the screen of the System Security Configuration, and then
you can see Syslog Transmission Configuration Menu as Figure 3-12.
configure Syslog servers as the destination of transmitting system-log on this
screen.
PNxxxxxx Local Management System
System Security Configuration -> Syslog Transmission Configuration Menu
Status: Disabled
Syslog Server List:
No. IP Address
---- -------------
1 0.0.0.0
2 0.0.0.0
3 0.0.0.0
4 0.0.0.0
-------------------------------- <COMMAND> -----------------------------------
Set Server [S]tatus
Set Server [F]acility [C]lear Server Information
Command>
Enter the character in square brackets to select option
Figure 3-12: Syslog Transmission Configuration
Screen Description
Status Displays the status of the configuration of Syslog server. The factory default
settings is "Disable".
Enabled
Disabled
No. Displays the management number of Syslog server.
IP Address Displays an IP address of the Syslog server.
Facillity Displays the Facillity value.
The following describes commands to be used on this screen.
S Configures the status of Syslog Transmission.
1. Press S (command), and then the appearance of the command prompt becomes "Enable
or Disable Server (E/D)>". After that, Press E" to enable and D to disable.
F Configures Facillity. Only information on Syslog server with an IP address configured can change
facility.
1. Press F (command), and then the appearance of the command prompt becomes "Enter
manager entry number>". After that, enter the number to be configured.
2. The appearance of the command prompt becomes "Enter Server Facility>". Then enter
the value in the range from 0 to 23.
Facility
----------
Facility0
Facility0
Facility0
Facility0
Set Server [I]P
The configuration of Syslog server is enabled.
The configuration of Syslog server is disabled.
44
[Q]uit to previous menu
You can