Telnet Access Limitation Configuration - Panasonic GA-ML Series Manual

3.5.1.

Telnet Access Limitation Configuration

Press A (command) on the screen of System Security Configuration, and then you
can see Telnet Access Limitation Menu as Figure 3-10. You can perform the limita-
tion configuration of equipment (or device) that accesses this device through
Telnet, on this screen.
PNxxxxxx Local Management System
System Security Configuration -> Telnet Access Limitation Menu
Telnet Access Limitation :
No. IP Address
--- ---------------
1 <empty>
2 <empty>
3 <empty>
4 <empty>
5 <empty>
-------------------------------- <COMMAND> -----------------------------------
[E]nable/Disable Telnet Access Limitation
[A]dd IP Address and Subnet Mask
[D]elete IP Address and Subnet Mask
[M]odify IP Address and Subnet Mask
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option
Figure 3-10: Telnet Access Limitation Configuration
The following describes commands to be used on this screen.
E Configures to enable or disable the access limitation (or restriction) from Telnet.
The factory default settings is "Disabled".
E Enables the access limitation. More than one IP address, to allow, needs to be configured
when enabling the access control (or limitation).
D Disables the access control.
Disabled
Subnet Mask
---------------
<empty>
<empty>
<empty>
<empty>
<empty>
40