Makita DFT085F Instruction Manual page 7

Reversing switch action
A
► 1 . Reversing switch lever
LED indicator / Beeper
► 1 . LED indicator
LED indicator / Beeper on the tool shows the following functions.
Function
Check of the LED indi-
cator, light and beeper
operation
Detection of switch
trigger operation when
installing battery
Auto-stop with fastening
completion
Alarm against insuffi-
cient fastening
Double-hitting detection
1
Status of the tool
When the battery Lights up first in green,
cartridge is installed, next red.
the tool checks for its (And then the light
LED indicator, light and comes on.)
beeper.
When the battery car- Flickers in red and green
tridge is installed with alternatively.
the switch trigger pulled,
the tool stops to avoid
unintentional start.
The preset fasten- Lights up in green for
ing torque has been approximately one
achieved and the tool second.
has stopped.
The preset fastening Lights up in red.
torque has not been
achieved, because
the switch trigger has
released before complet-
ing the fastening.
When the operator Lights up in red.
starts to re-fasten an
already-fastened screw,
the tool detect it and
stops.
CAUTION:
rotation before operation.
CAUTION:
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
always set the reversing switch lever to the neu-
tral position.
B
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
1
Status of the LED indicator/beeper
LED indicator
A series of very short
beeps
A series of short beeps
A long beep
A long beep
7 ENGLISH
Always check the direction of
Use the reversing switch only after
When not operating the tool,
Action to be taken
Beeper
Release the switch
trigger.
–
Retighten the screw.
–
–
–