Makita DUR369N Instruction Manual page 11

Installing the handle
1. Attach the upper and lower clamps on the damper.
2. Put the handle on the upper clamp and fix it with
hex socket head bolts as illustrated.
1
► 1. Hex socket head bolt 2. Handle 3. Upper clamp
4. Damper 5. Lower clamp
Hex wrench storage
CAUTION:
Be careful not to leave the hex
wrench inserted in the tool head. It may cause
injury and/or damage to the tool.
When not in use, store the hex wrench as illustrated to
keep it from being lost.
► 1. Hex wrench
► 1. Hex wrench
2 3
1
1
Correct combination of the cutting
tool and the protector
CAUTION:
nation of cutting tool and the protector. A wrong
combination may not protect you from the cutting tool,
flying debris, and stones. It can also affect the bal-
ance of the tool and result in an injury.
Cutting tool
Nylon cutting head
4
5
Installing the protector
WARNING:
guard illustrated in place. Failure to do so can
cause serious personal injury.
CAUTION:
the cutter for cutting the nylon cord.
Attach the protector to the clamp using bolts.
2
► 1. Clamp 2. Protector 3. Cutter
Installing the cutting tool
CAUTION:
wrench(es) to remove or to install the cutting tool.
CAUTION:
inserted into the tool head after installing the
cutting tool.
NOTE: The type of the cutting tool(s) supplied as
the standard accessory varies depending on the
countries.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
11 ENGLISH
Always use the correct combi-
Protector
Never use the tool without the
Take care not to injure yourself on
3
Always use the supplied
Be sure to remove the hex wrench
1