Battery Protection System - Makita DML809 Instruction Manual

Use with AC power:
2
4
1
3
When using the appliance with AC power, use the power
cord which is supplied with the appliance. Let the female
plug insert to the appliance and connect the male plug
to an outlet.
CAUTION:
• Insert the female plug into the appliance first
completely, then connect the male plug to an outlet.
• Always close the socket cover firmly when the power
cord is not plugged.
NOTE:
• The AC power does not charge the battery inserted to
the appliance.
• Even operating in DC power, the appliance
automatically changes to AC power when the power
cord is plugged in.
Organizing the power cord:
1
1. Power cord
2. Fastener
Coil power cord on stand tightly, then clip end of the
cord by using fastener attached.
1. Power cord
2. Socket cover
3. Female plug (for
the appliance)
4. Male plug (for
AC source, the
shape varies
from country to
country)
2
6 English
Turning on the light and brightness mode
selection
1
1. Switch: Press the switch once, the light turns on (At
the same brightness mode as the last setting). Press
the switch again, the light turns off.
2. Brightness mode selection: Brightness sequence is:
High mode / Mid mode / Low mode / High mode for
each press when the light is on.

Battery protection system

The appliance is equipped with a battery protection
system to extend battery life. When the battery becomes
low, the LED lights go out except one LED as illustrated.
Then approximately five to ten minutes later, the system
automatically cuts off power. In this case, remove the
battery from the tool and charge the battery.
Cooling fan
This appliance is equipped with the cooling fan.
The cooling fan may work to cool the appliance even
after the appliance is turned off. Sound of air comes out
when the cooling fan is working.
This is not malfunction of the appliance.
1. Switch
2. Brightness mode
selection
2