Advertisement
Configuring your camera with IP
Installer (continued)
Setting up your wireless configuration for the DCS-5300W
The DCS-5300W is pre-configured to connect to any D-Link wireless routers and
adapters by default. If the settings are changed on the other devices, then the DCS-
5300W will need to be configured to match those settings also.
Type in your SSID and Connection type
consistent with your network. (If you are
unsure, please contact your network
administrator).
If you have an access point, choose Infrastruc-
ture, or Ad Hoc if you will be connecting your
DCS-5300W directly to your PC
Choose the channel that is the same as your
other wireless devices that you would like to
connect to, although this is not very critical if
you have the rest of your configuration correct.
The DCS-5300W will automatically insert the
correct channel for you.
You can choose different transmission rates to
apply if you need to restrict the camera's
bandwidth.
Preamble Type-
Preamble. The Preamble Type defines the
length of the CRC (Cyclic Redundancy
Check) block for communication between the
DCS-5300W and roaming wireless adapters.
Please see the manual for details.
You can enable encryption here (up to 256-bit).
Once you have filled the encrytion box (only
one needs to be filled if you will not be using
the camera in another network with different
encryption), check the Data encryption box.
16-bit requires 10 hex, or 5 ASCII charactors
128-bit requires 26 hex, or 13 ASCII charactors
256-bit requires 58 hex, or 29ASCII charactors.
select Short or Long
7
Click
Next
Advertisement
