Advertisement
System Requirements
•
Internet Explorer 5.x or above
•
CPU: Pentium III, 800 MHz or above (Required for use with IP surveillance software)
•
Memory Size: 128 MB (256 MB recommended)
•
VGA card resolution: 800x600 or above
Hardware Installation
Connect the Ethernet Cable
It is recommended that the DCS-5300W be connected to
an Ethernet cable for initial configuration. Connect one end
of the Ethernet cable to the network cable connector
located on the Internet Camera's back panel and attach
the other end to a router, switch, or gateway on the
network.
If you connect this camera directly to
a PC, you will need a cross-over
Ethernet cable. If you plug the camera into a
hub or router, you will be able to use the cable
included with your camera.
Attach the Antennas to the Camera
If you will be using the DCS-5300W in a wireless network,
attach the antennas to the back of the camera by turning
the antennas in the clockwise direction until snug, do not
over tighten.
2
Advertisement
