Blade Installation - Honeywell 10282 Manual

20. Remove motor screws and motor blocks from
underside of the motor assembly. Discard the
motor blocks but save the motor screws for blade
arm attachment (Fig. 20).
Motor Screw
21. Partially insert the blade screws along with the
blade washers through the blade and into the
blade arm. Tighten each blade screw with a Phillips
screwdriver (not included) starting with the one
in the middle. Repeat this step for the remaining
blades and blade arms (Fig. 21).
Blade Screw Blade Washer
22. Insert two previously removed motor screws
through one blade arm and blade isolator. Insert
the motor screws into the underside of the motor
assembly. Tighten motor screws securely. Repeat
with remaining blade arms, secure each blade arm
before proceeding with to the next (Fig. 22).
Motor Screw

BLADE INSTALLATION

Motor Block
Fig. 19
Fig. 20
Fig. 21
Fig. 22
13
Motor Screw
Blade Screw
Blade Washer
Blade
Blade Arm
Motor Screw
Blade Arm
Motor
Block