Blade Installation - Honeywell PALM ISLAND Manual

19. Remove motor screws from underside of motor and
save for blade arm attachment. Discard the plastic
motor blocks and washers but keep the motor
screws (Fig. 19).
Motor Screw Washer
20. Partially insert three blade screws along with its
spring washer and flat washer to attach one blade
arm to a blade. Tighten each blade screw, starting
with the one in the middle. Repeat this step with
each blade (Fig. 20).
Blade Screw Spring Washer
21. Insert two previously removed motor screws through
one blade arm and blade isolator and then into the
motor. Tighten motor screws securely. Repeat with
remaining blade arms, making sure to completely
secure each blade arm before proceeding with to the
next (Fig. 21).

BLADE INSTALLATION

Motor Block
Flat Washer
13
Fig. 19
Motor Block
Motor Screw
Fig. 20
Blade Screws and
Blade
Blade Arm
Fig. 20
Blade Isolator
Motor Screw
washers
Blade Arm