Honeywell 10282 Manual page 8

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
10. Slide the downrod into the yoke of the motor
assembly, align the holes, and reinstall the
downrod pin and downrod clip. Then retighten the
two set screws (Fig. 10).
11. Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires,
it is suggested that you do so in the following
manner: Take the lead wires and make sure that
you have pulled them all the way through the top
of the downrod and measure 8 in. of lead wire, and
then cut the excess wire off with wire cutters (not
included) (Fig. 11).
12. If you decided to cut back the lead wire in Step 11,
strip 1/2 in. of insulation from the end of the white
wire. Twist the stripped ends of each strand of
wire within the insulation with pliers (not included)
(Fig. 12).
Note: If you did not cut back the lead wires in
Step 11, Step 12 is not necessary and you may
proceed to Step 13 instead.
Fig. 10
Downrod
Pin
Setscrew
Fig. 11
Fig. 12
8
Downrod
Downrod
Yoke
Cut Wires
Stripped
Wires
Clip