Table of Contents
Advertisement
Connect to the Appliance
Router: 192.168.42.1
–
Click OK.
Step 7
The Cisco C390 appliances have five gigabit network ports and a Management
port, as shown in the figure on the following page . At least one static IP address
is required to send and receive email.
You can receive and deliver email from a single connection to either network
port if your network topology dictates it. Two IP addresses can be configured on
one network interface.
Or, you can connect the Data 1 network port to your public network and
connect the Data 2 network port to your private network.
To access and manage the appliance by Ethernet, use the Management network
port. The IPv4 address that has been assigned to the Management port by the
factory is 192.168.42.42.
For serial access to the appliance's console port, use the RJ-45 to DB-9 Rollover
cable provided in the accessory kit to connect the computer to the console port
on the appliance.
Item
Port
1
Data 1
2
Data 2
3
Data 3
Description
A Gigabit Ethernet customer data
interface.
A Gigabit Ethernet customer data
interface.
A Gigabit Ethernet customer data
interface.
7
Advertisement
Table of Contents
