Log In to the Appliance
Web-Based Interface
Command-Line Interface
You can log in to the Cisco C390 appliance using one of two interfaces: the
web-based interface or the command-line interface.
For web browser access via the Ethernet port (see the
Step 1
Appliance" section on page
interface by entering the following URL in a web browser:
http://192.168.42.42
Log in with the following credentials:
Step 2
Username: admin
•
Password: ironport
•
Access the command-line interface locally or remotely:
Step 1
To access the CLI locally, set up a terminal to connect to the serial
•
port using 9600 bits, 8 bits, no parity, 1 stop bit (9600, 8, N, 1) and
flow control set to Hardware. To physically connect the terminal,
see the
"Connect to the Appliance" section on page
To access the CLI remotely, initiate an SSH session to the IP address
•
192.168.42.42.
Log in as admin with the password ironport.
Step 2
At the prompt, run the systemsetup command.
Step 3
7), go to the appliance's management
"Connect to the
7).
9