NETGEAR R6400v2 User Manual page 37

5. In the Internet Connection Type menu, select PPPoE.
6. Enter the settings that your service provider gave you.
If your service provider gave you only one user name and password, the service provider
most likely supports dual stack PPPoE (a single PPP session). If the service provider
gave you two user names and passwords for IPv4 and IPv6, then the router must use
different PPP session.
• To use separate PPP sessions (the default setting), leave the Use the same Login
information as IPv4 PPPoE check box cleared and complete the PPP Login and
Password fields.
• To use a single PPP session to establish the IPv4 and IPv6 Internet connection,
select the Use the same Login information as IPv4 PPPoE check box.
The page adjusts and the router automatically detects the information in Router's
IPv6 Address on WAN field. Go to
Note: If you do not see the Use the same Login information as IPv4
PPPoE check box, make sure that PPPoE is selected from the
Internet Service Provider menu on the Internet Setup page. For
more information, see
Login on page 24.
The Router's IPv6 Address on WAN field shows the IPv6 address that is acquired for
the router's WAN (or Internet) interface. The number after the slash (/) is the length of the
prefix, which is also indicated by the underline (_) under the IPv6 address. If no address
is acquired, the field displays Not Available.
The Router's IPv6 Address on LAN field shows the IPv6 address that is acquired for
the router's LAN interface. The number after the slash (/) is the length of the prefix, which
is also indicated by the underline (_) under the IPv6 address. If no address is acquired,
the field displays Not Available.
7. In the Login field, enter the login information for the ISP connection.
AC1750 Smart WiFi Router
Step 10.
Specify an Internet Connection That Uses a
Specify Your Internet Settings
37