X-Y Carriage (X Carriage Position) - Brother Pe-150 Service Manual

19. X - Y CARRIAGE (X CARRIAGE POSITION)
STANDARD
The X carriage must be installed perpendicularly to the embroidery machine arm (upper shaft).
Select the pre-programmed "frame pattern (square border)", enlarge the size to maximum, and then touch the
"TRIAL" to move the embroidery frame: the embroidery presser foot should not contact the inside of the
embroidery frame at anywhere.
ADJUSTMENT
1. Loosen the three mounting screws of the X carriage.
2. Move the X carriage right or left so that the X carriage is perpendicular to the upper shaft.
3. Tighten the three mounting screws of the X carriage.
4. Stretch a piece of felt in the embroidery frame and then set the frame in the embroidery machine.
5. Select the preprogrammed "frame pattern (square border)", enlarge the size to maximum, and then touch
the "TRIAL" to move the embroidery frame. Confirm that the embroidery presser foot does not contact the
inside of the embroidery frame at anywhere.
- 32 -