Brother Pe-150 Service Manual page 12

9. Disconnect the 13 electrical connectors, remove the two screws, and then remove the main PC board.
10. Remove the screws and then remove the embroidery presser foot and needle.
11. Remove the two screws of the thread path assembly, remove the tension spring, and then remove the thread
path assembly.
12. Remove the two screws and then remove the solenoid holder assembly.
13. Remove the screw of the main motor cover and then remove the main motor cover. (220 to 240 V models
only)
14. Remove the two screws of the motor holder, disconnect the electrical connectors and then remove the motor
holder assembly.
15. Remove the screws and then remove the shutter cover.
16. Remove the screw of the back cover.
17. Remove the three screws of the fixation unit.
18. Remove the two screws of the upper shaft bushing fixation and then remove the upper shaft bushing
fixation.
19. Remove the main shaft assembly and presser unit.
20. Remove the two screws and then remove the handle.
21. Remove the two screws and then remove the bobbin winder holder assembly.
- 10 -