Brother Pe-150 Service Manual page 11

1. DISASSEMBLY AND REASSEMBLY PROCEDURES FOR EXTERNAL
PARTS AND MAJOR COMPONENTS
1. Raise the presser foot lever, remove the screw, and then remove the face plate from the left side.
2. Remove the two screws of the needle plate and then lift out the needle plate.
3. Loosen the screw of the X carriage cover and then remove the X carriage cover.
4. Remove the four screws of the bottom plate and the two screws of the cover, and then remove the bottom
plate.
5. Remove the four screws of the rear cover and then remove the rear cover.
6. Remove the main cover to the left side.
7. Remove the four screws of the front cover. Then remove the front cover from the lower section of the thread
path cover and the part around the tension control dial in that order, and then disconnect the three electrical
connectors to remove the front cover.
8. Remove the belt cover.
- 9 -