Table of Contents
Advertisement
1
2
3
4
007014
Anti dry fire mechanism
This tool is equipped with an anti dry fire mechanism.
When there are a few nails remaining in the magazine,
the contact arm will be locked in the undepressed
position to prevent the tool from being activated. Load
more nails to resume operation.
Jammed nailer
1
2
3
4
004308
CAUTION:
Always lock the trigger, disconnect the hose and
•
remove the nails from the magazine before clearing
a jam.
When the nailer becomes jammed, do as follows:
Insert a small rod or the like into the ejection port and tap
it with a hammer to retract the driver.
Use pliers to bend the jammed nail so that the nail head
comes out of the slot in the driver guide. Then remove
the jammed nail.
004309
1. Continuous
nailing
2. Trigger lock
3. Lock lever
4. Intermittent
nailing
1. Hammer
2. Small rod
3. Ejection port
4. Driver
1. Pliers
2. Slot
1
2
Nails
Nail
004310
Handle nail coils and their box carefully. If the nail coils
have been handled roughly, they may be out of shape or
their connector breaks, causing poor nail feed.
Avoid storing nails in a very humid or hot place or place
exposed to direct sunlight.
Humid
Nail
004311
MAINTENANCE
CAUTION:
Always disconnect the air hose from the tool before
•
attempting to perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Maintenance of the nailer
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
007015
With tool disconnected, make daily inspection to assure
free movement of the contact element and trigger. Do not
use tool if the contact element or trigger sticks or binds.
8
Hot
Advertisement
Table of Contents
