Operation; Unloading The Nailer; Connecting The Air Hose - Makita AN923 Instruction Manual

Pneumatic framing nailer
Hide thumbs Also See for AN923:
Table of Contents

Advertisement

007008
Pull the pusher lever to the rear to engage the pusher to
the last nail.

Unloading the nailer

3
007009
Pull the pusher lever to the rear. Return the pusher lever
back while keeping the pusher depressed to disengage it
from the strip of nails.
Depress the nail stopper and remove the strip of nails
from the magazine.
007010

Connecting the air hose

1
007011
Lock the trigger. Slip the air socket of the air hose onto
the air fitting on the nailer. Be sure that the air socket
locks firmly into position when installed onto the air fitting.
A hose coupling must be installed on or near the tool in
such a way that the pressure reservoir will discharge at
the time the air supply coupling is disconnected.
1. Pusher
1
1. Pusher lever
1
2. Depress
3. Return
2
1. Nail stopper
1
1. Air socket
2
2. Air fitting

OPERATION

CAUTION:
Make sure all safety systems are in working order
before operation.
1.
To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
1
007012
2
007013
2.
Pull the trigger first and then place the contact
element against the workpiece.
No. 1 method is for intermittent nailing, when you
wish to drive a nail carefully and very accurately.
No. 2 method is for continuous nailing.
CAUTION:
However when the tool is set to the "Intermittent
Nailing" mode, WITH THE TRIGGER HELD IN A
HALF-PULLED POSITION, an unexpected nailing
could occur, if contact element is allowed to
re-contact against the workpiece or the other
surface under the influence of recoil.
In order to avoid this unexpected nailing, perform
as follows;
A.
Do not place the contact element against the
workpiece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds
after nailing.
For No. 1 method, set the change lever to
the
position.
For No. 2 method, set the change lever to
the
position.
After using the change lever to change the nailing
method, always make sure that the change lever is
properly set to the position for the desired nailing
method.
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

An943

Table of Contents